Maintenance of laser machine

Maintenance of laser machine

Laser machine must be maintained in order to use a more permanent.

1.Replacement of water and clean water tank

Suggestion: wash the laser tank and replace the circulating water once per week
Note: Before open the machine must ensure that the laser tube is filled with circulating water.
The water quality and the water temperature of the circulating water directly affect the service life of the laser tube, it is recommended to use pure water, and the water temperature is controlled at 35 degrees Celsius. For more than 35 degrees Celsius to replace the circulating water, or add ice to water to reduce the water temperature, (recommend that the user choose a water chiller, or use two water tanks).
The tank cleaning: first turn off the power supply, the water inlet pipe is pulled out, so that the laser tube water automatically flows into the water tank, water tank is opened, remove the water pump, clear water pump on the dirt. The cleaning tank clean, replacing the good water circulation, water return tank will connect to pump water pipe is inserted into the water inlet, the joint order. The pump is powered by a single pass and run for 2-3 minutes (the laser tube is filled with circulating water).

2.Fan cleaning

Use the wind turbine for a while, the wind machine inside accumulate a lot of solid dust.The fan produces a lot of noise, but also not conducive to the exhaust and odor. When appear fan inadequate suction exhaust is not smooth, please turn off the power, wind turbine air inlet pipe and an air outlet pipe, remove dust inside, and then inverted fan and pulling the wind leaf relief until clean, and then install the fan.

3.Lens cleaning

There are three mirrors and a focusing mirror (No. 1 mirror is located in the laser tube's launch exit, which is the upper left corner of the machine.
No. 2 is located in the left end of the beam reflector,
No.3 mirror is at the top of the fixed part of the laser head, poly focal lens in the lens barrel is arranged at the lower part of the laser head can be adjusted).
The laser is reflected through the lens, focusing from the laser hair shot out.
Lenses are easily stained with dust or other contaminants, resulting in the loss of laser or lens damage, No. 1 and No. 2 lens cleaning should not be removed, only to be dipped in a clean liquid of the mirror carefully along the central edge of the lens to the edge of the rub.
Note: 1. The lens should be gently wipe, do not damage the surface coating; 2. Clean the process should be handled with care, to prevent the fall; 3. Focusing mirror installation please be sure to keep concave downward.
The 3 lens and the focusing mirror is removed from the frame, use the same method to wipe, wipe after it is put into the can.

4.Cleaning of guide rail

Guide, linear axis, as one of the core components of the device, its function is to guide and support. In order to ensure that the laser machine has higher accuracy, it is required that the guide rail, straight line has a high accuracy and good motion stability. In the process of operation, because of the large amount of corrosive dust and smoke, the smoke and dust in the process of processing will produce a lot of dust and smoke.The smoke and dust be in a long time, a large number of deposits in the rail, linear axis surface, the machining accuracy of the device has a great impact, and will be in the guide line of the formation of pitting, shorten the service life of the equipment.

Copy from http://www.xjrouter.com/news/Maintenance%20of%20laser%20machine.html